Dell PowerConnect 6224 User Manual

524 Configuring Routing
Defining an OSPF Area Range
1. Open the OSPF Area Range Configuration page.
2. Enter Area ID, IP Address, Subnet Mask, LSDB Type and Advertisement.
3. Click the Add check box.
4. Click Apply Changes .
The OSPF area range is defined and configured. All configured OSPF area ranges are displayed in the
table on the
OSPF Area Range Configuration page.
Removing an OSPF Area Range Configuration
1. Open the OSPF Area Range Configuration page.
2. Select the Remove check box in the row of the Area ID to be deleted.
3. Click Apply Changes .
The address range is removed from the area configuration.
OSPF Area Range Configuration CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• OSPF Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-9. OSPF Area Range Configuration Commands
CLI Command Description
area range Creates a specified area range for a specified NSSA.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)