Dell PowerConnect PC5524 User Manual

418 sFlow Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\750_sFlow.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Command Mode
Global Configuration mode
User Guidelines
If the IP address of the sFlow receiver is set to 0.0.0.0, no sFlow datagrams are
sent.
sflow flow-sampling
Use the sflow flow-sampling Interface Configuration mode command to
enable sFlow Flow sampling and configure the average sampling rate of a
specific port. Use the no form of this command to disable Flow sampling.
Syntax
sflow flow-sampling rate receiver-index [max-header-size bytes]
no sflow flow-sampling
Parameters
 rate—Specifies the average sampling rate (Range: 1, 1024–1073741823.)
 receiver-index—Index of the receiver/collector (Range: 1–8.)
 bytes—Specifies the maximum number of bytes that would be copied from
the sampled packet. If unspecified, defaults to 128. (Range: 20–256.)
Default
Disabled
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
A new sampling rate configuration is not immediately loaded to the hardware.
It will be loaded to the hardware only after the next packet is sampled (based
on the current sampling rate).

Dell PowerConnect PC5524 Specifications

General

Brand	Dell
Model	PowerConnect PC5524
Category	Switch
Language	English