Dell PowerConnect PC5524 User Manual

LLDP Commands 425
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\LLDP.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Parameters
This command has no arguments or keywords.
Default
Enabled
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
LLDP manages LAG ports individually. LLDP data received through LAG
ports is stored individually per port.
LLDP operation on a port is not dependent on the STP state of a port. I.e.
LLDP frames are received on blocked ports.
If a port is controlled by 802.1X, LLDP would operate only if the port is
authorized.
Example
console(config)# interface gigabitethernet 1/0/1
console(config-if)#
lldp receive
lldp timer
Use the lldp timer Global Configuration mode command to specify how
often the software sends Link Layer Discovery Protocol (LLDP) updates. Use
the no form of this command to restore the default configuration.
Syntax
lldp timer seconds
no lldp timer
Parameters
seconds—Specifies, in seconds, how often the software sends LLDP updates.
(Range: 5?32768 seconds)

Dell PowerConnect PC5524 Specifications

General

Brand	Dell
Model	PowerConnect PC5524
Category	Switch
Language	English