548 GVRP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\GVRP.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
An access port does not dynamically join a VLAN because it is always a
member of one VLAN only. Membership in an untagged VLAN is propagated
in the same way as in a tagged VLAN. That is, the PVID must be manually
defined as the untagged VLAN VID.
Example
The following example enables GVRP on gigabitethernet port 1/0/6.
Console(config)#
interfa
ce gigabitethernet
1/0/6
Console(config-if)#
gvrp enable
garp timer
Use the garp timer Interface Configuration (Ethernet, port channel) mode
command to adjust the values of the join, leave and leaveall timers of GARP
applications, such as GVRP. Use the no form of this command to restore the
default configuration.
Syntax
garp timer
{join | leave | leaveall} timer-value
no garp timer
Parameters
•
join
|
leave
|
leaveall
—Specifies the type of timer for which the timer
value is specified. The possible values are:
To Next Page
Loading...
Need help?
General