Dell U2722DE - Page 81

Operating the Monitor | 81
A message is displayed while the cable supporting DP alternate mode is connected to
the monitor under the following conditions:
• When Auto Select for USB-C is set to Prompt for Multiple Inputs.
• When the USB-C cable is connected to the monitor.
Switch to USB-C Video Input:
Yes
No
If the monitor connect with two ports or more, when the Auto of Input Source is
selected, it will turn to the next port with signal.
Exit
DP HDMI
USB-C 90W
Auto
Select OSD items of On in Standby Mode in Personalize feature, the following
message will appear:
Changing to this setting ( without symbol) will increase
power consumption. Do you want to continue?
Yes
No
If adjust the Brightness level above the default level over 75%, the following message
will appear:
Adjusting to this value will increase power consumpiton above the
default level. Do you want to continue?
Yes
No
• When user selects “Yes”, the power message is displayed only once.
• When user select ‘No’, the power warning message will pop-up again.
• The power warning message will appear again only when the user does a Factory
Reset from the OSD menu.