Thank you for choosing this De’Longhi heater. To get the
very best out of your new heater it is advisable to read
these instructions before using it.This will ensure that you
gain optimum results and use the appliance safely.
Electrical connection
- Before plugging the appliance into the mains, check that your
supply voltage is the same as that shown on the rating plate of
the appliance.
- If using more than one appliance at a time, it is important to
ensure that the ring main is adequate to cope with the power
requirements.
- It is important to ensure that the socket is adequately earthed.
- This appliance complies with EEC directive 89/336 regarding
electromagnetic compatibility.
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same socket
for other appliances.
OPERATION AND USE
1. Make sure the appliance is off before plugging into the mains
2. To turn the appliance on, the switch at the back must be in the
I position.The appliance emits a beep.The “ON” light also comes
on and remains lit while power to the appliance is on.
3. Press button A to turn the appliance on.
4. The appliance starts up in LOW mode (minimum heat output).
The display shows room temperature.
5. Press the Mode button (B) to switch to HIGH mode (maxi-
mum heat output).The display shows room temperature.
6. Press the Mode button (B) again to switch the appliance to
Auto mode.The display shows both room temperature and the
temperature set point.To change the temperature set point, use
the + and – buttons.
7. Press the Mode button (B) a fourth time to switch the applian-
ce back to LOW mode.When the Mode button is pressed con-
tinuously, the appliance switches through the following modes in
sequence: LOW HIGH AUTO.
8. To turn the appliance off, press button A and place the switch
on the back in the 0 position.
DCH2570E
3
To Next Page
Loading...
Need help?
General
