DeLonghi DCH7993ER.BC User Manual

9
less than 4m
2
.
- Before putting the appliance away, make sure it is com-
pletely o and unplugged from the mains socket. Wrap
the cable around the base.
Do not store in dusty atmospheres.
- Do not rest anything on the appliance.
- Do not use the appliance to dry laundry. Do not obstruct
the air intake and outlet grilles (danger of overheating).
- Do not use the appliance near walls, furniture, curtains,
etc.
Safety functions
- Safety device: the appliance is tted with a safety
device which switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the mains socket
for a few minutes, remove the cause of overheating
then plug in again. If the appliance doesn't work please
contact the De'Longhi Customer Service.
- Tip over safety device: a tip over safety device turns
the appliance o if it falls over or is positioned inappro-
priately in such a way as to jeopardise safety.
The appliance emits a beep and a dot ashes on the di-
splay. The appliance resumes operation a few seconds
after being placed in an upright position again.
Disposing of the appliance
The appliance must not be disposed of with hou-
sehold waste, but taken to an authorised waste se-
paration and recycling centre.
DESCRIPTION
(see g. 1)
A ON/STAND-BY button
B +/- adjustment buttons
C MODE button (selects the operating mode)
D “ECO plus” button
E Timer button
F Swing button
G Remote control receiver
H Remote control
I Indicator light
J Air intake grille
K Filter
USE
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.
Electrical connection
- Before plugging the appliance into the mains socket,
check that the mains power supply corresponds to the
value indicated on the rating plate and that the mains
power supply is adequate for the load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/
EEC ON RADIO INTERFERENCE SUPPRESSION.
Operation and use
- Plug into the mains socket.
- The appliance emits a beep. The indicator light (I) comes
on and remains lit while the appliance is powered.
- The appliance switches to stand-by. A dot ashing
on the display means the tip over device has been
activated. See paragraph: “Safety functions”.
- Press the ON/STAND-BY (A) to turn the appliance on.
It begins heating the room according to the current
settings.
- Press the MODE button (C) to select one of the following
operating modes:
- Fan
In this mode, only the fan operates and the appliance
does not heat the room.
- Freeze prevention
In this mode, the appliance keeps the room at a
temperature of 7°C to avoid freezing.
- Heating
In this mode, the desired temperature can be selected
by pressing the adjustment buttons + and – (B):
- Heating Silent+
The appliance operates at minimum power, automati-
cally reducing energy consumption and noise level. The
tones emitted by the commands are lower than in other
modes for even more silent operation.
- Heating
The appliance operates at medium power.
- Heating
The appliance operates at high power to heat the room
rapidly.
“ECO plus” function
The “ECO plus” function is available in Heating 1, 2 and 3 modes

DeLonghi DCH7993ER.BC Specifications

General

Brand	DeLonghi
Model	DCH7993ER.BC
Category	Heater
Language	English