3
BEFORE YOU START
Corner
Protectors
CAUTION
Installing glass panels with any nicks, chips or scratches
may result in personal injury, property damage, or
product failure.
La instalación de los paneles de vidrio con mellas, astillas
o rayones puede provocar lesiones, daños a la propiedad
o fallas del producto.
Measurements
must be within
3/8” of each
other.
X1"X1"
X2"
X2"
BEFORE BEGINNING YOUR INSTALLATION,
fully inspect the edges and corners of your glass
panels for any nicks, chips or scratches which
might have occurred during the transportation
of your glass panels. If you see any wear or
damage to your glass panels call Delta Shower
Doors Customer Care Team at 1-800-964-4850.
NOTICE:
• Tempered safety glass is stronger than normal glass but is not unbreakable. A scratch to the glass or contact with a hard surface (such as a screw
head or tile/concrete oor) can cause it to break or weaken. This could, immediately or even at a later time, cause the glass panel to shatter into many
small pieces without apparent cause. When it does break, it loudly explodes into thousands of smaller pieces (the smaller pieces reduce the risk of
personal injury).
CAUTION
To reduce the risk of personal injury or glass breakage:
• During installation tempered glass should not come in direct contact with metal parts or hard surfaces (such as tile/concrete ooring) or it may shatter.
Gaskets and bushings must always be used between glass and metal.
• DO NOT touch the edges of tempered glass with tools. DO NOT attempt to cut tempered glass or it will shatter.
• Keep the corner protectors on the glass during unpacking and installation. DO NOT remove them until after the glass panels are installed unless
instructed otherwise.
• Once installed, glass panels must be clear of all shower environment obstructions. Ensure appropriate clearances exist before beginning the installation
process.
• All components must be installed as instructed with particular attention to Grab Bumpers, Glazing Components, Gaskets and Bushings.
• Door installation requires at least two people.
NOTE:
• Enclosure widths:
– 48" Shower: 44" minimum - 48" maximum
– 60" Shower: 52" minimum - 60" maximum
• Walls must be within 3/8" of plumb (vertical) when facing the front of the shower. Dimensions across the top and bottom of
shower should be within 3/8" of each other.
• Enclosure must be level.
• Cover tub or shower drain with rag or tape to avoid loss of small parts.
• Follow the silicone sealant manufacturer's instructions for application and curing time.
• Limited 5 Year Warranty, conditions may apply - See www.libertyhardware.com/warranty for additional details or call
Delta Shower Doors Customer Care Team at 1-800-964-4850.
CARE AND CLEANING
Use ONLY mild detergents or warm, soapy water. Use ONLY non-abrasive cloth or sponge. ALWAYS rinse surfaces after cleaning.
Before cleaning this product with cleaning products, test a small, inconspicuous area.
CAUTION: Manufacturer does not recommend the use of cleaning products that contain any of the following chemicals. Use of
products containing these chemicals can cause the products to discolor and will void the warranty.
• Naphtha
• Hydrogen Peroxide Solution (common household peroxide)
• Toluene
• Ethyl Acetate
• Lye (common in drain cleaner)
• Acetone
For optimal maintenance it is recommended that the glass panels be squeegeed on a regular basis after the shower is used.
For further inquiries, contact Delta Shower Doors Customer Care Team at customersolutions@deltashowerdoors.com or call 1-800-964-4850.
To Next Page
Loading...
Need help?
General
