To Next PageTo Next Page
Need help?Do you have a question about the Delta ShopMaster S26-272L and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Motor Power | 1.5 HP |
| Arbor Size | 5/8 in |
| Max Cut Depth at 90° | 3.5 inches |
| Max Cut Depth at 45° | 2.25 inches |
| Blade Diameter | 10 in |
| Motor | 120 V, 60 Hz, Single Phase |
Explains the safety concept of double insulation in power tools.
Detailed descriptions of the saw's motor, fence, controls, and safety features.
Covers features like blade guards, laser guide, power switch, and safety toggle.
Steps and precautions for safely preparing the saw for moving.
Information on the lock pin used for storage and transport.
Describes the base design and integrated handles for carrying.
Instructions for securely mounting the saw to a workbench or stable surface.
Instructions for installing workpiece support extensions.
Guide on how to install and use the work clamp.
Steps for attaching the dust collection bag to the saw.
Detailed instructions for safely installing or replacing the saw blade.
Procedure for ensuring the saw blade is properly aligned with the table.
How to operate and utilize the laser guide for precise cutting.
Method to prevent unauthorized operation using a padlock.
Describes the toggle switch required to start the saw motor.
Instructions for performing slide cuts with the miter saw.
Guidance on making angled cuts using the bevel function.
How to perform cuts combining miter and bevel angles.
Techniques and angle settings for cutting crown molding accurately.
Advice on safely cutting warped or bowed workpieces.
How to secure wide workpieces for safe cutting.
Methods for providing adequate support for long workpieces.
Checking and ensuring the free movement of the saw arm pivot.
Procedure for adjusting the positive stop screw for blade alignment.
Checking the bevel pivot for smooth tilting and absence of play.
Initial setup and calibration of the laser guide system.
How to adjust the depth stop for through and non-through cuts.
Steps to extend or retract the adjustable fence.
Instructions for fine-tuning laser alignment for accurate cuts.
Adjusting the laser line to be parallel with the saw blade.
Adjusting the vertical angle of the laser line.
Adjusting the laser line's position relative to the actual cut.
Guidelines for cleaning the saw using compressed air and damp cloths.
General care and cleaning advice, avoiding solvents on plastic parts.
Steps for checking and replacing motor brushes.
Information on the lubrication of the tool's bearings.
Steps to diagnose and resolve issues when the machine fails to start.
Contact information and procedures for obtaining parts, service, or warranty.
Information on user-replaceable parts and where to order them.
Guidance on obtaining professional servicing and repairs for the tool.
How to obtain replacement warning labels if they are missing or illegible.
