.
I
ZONE2 ON/OFF button
This turns the power of ZONE2 (another room) on/off. (v p. 153)
J
ZONE2 SOURCE button
This selects the input source for ZONE2. (v p. 153)
K
DIMMER button
Each press of this switches the brightness of the display. (v p. 237)
L
STATUS button
Each press of this switches the status information that is shown on the
display.
M
QUICK SELECT buttons
With a single press of any of these buttons, you can call up various
settings you’ve registered to each button such as the input source,
volume level and sound mode settings. (v p. 142)
N
Headphones jack (PHONES)
This is used to connect headphones.
When the headphones are plugged into this jack, audio will no longer
be output from the connected speakers or from the PRE OUT
connectors.
NOTE
0
To prevent hearing loss, do not raise the volume level excessively when using
headphones.
O
SETUP MIC jack
This is used to connect the supplied Sound calibration microphone.
(v p. 197)
P
USB port (T)
This is used to connect USB storages (such as USB memory devices).
(v p. 74)
Contents
Connections Playback Settings Tips Appendix
19
Front panel Display Rear panel Remote Index
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
Weight and Dimensions
