8
ENGLISH
Set up speakers
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confi rm the setting Return to previous menu
3
Use ui to select “Mode”, and use
o p to select a detailed setting.
Mode :• LFE –
Mode
Select low range signals to be
reproduced by subwoofer.
• LFE : The low range signal of the channel set to
“Small” speaker size is added to the LFE signal
output from the subwoofer.
• LFE+Main : The low range signal of all channels
is added to the LFE signal output from the
subwoofer.
• “Mode” can be set when “Speaker Confi g.” –
“SW” (vpage7) is set to “Yes”.
• Play music or a movie source and select the
mode offering the strongest bass.
• Select “LFE+Main” if you want the bass signals
to always be produced from the subwoofer.
NOTE
If “Front” and “Center” for “Speaker Confi g.”
are set to “Large”, and “Mode” is set to “LFE”,
no sound may be output from the subwoofers,
depending on the input signal or selected
surround mode.
4
Press ENTER to enter the setting.
Bass Setting
1
Use ui to select “Bass Setting”, and
then press ENTER.
Bass Setting
LFE •120Hz–
2
Use o p to select the frequency.
LFE
Set LFE signal playback range.
• 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz
/ 200Hz / 250Hz
1
Use ui to select “Distance”, and
then press ENTER.
Distance
Meters :• 0.1m–
2
Use o p to change the step (minimum
variable distance).
0.1m : For changing in 0.1-meter steps.
0.01m : For changing in 0.01-meter steps.
Bass Setting
Default settings are underlined.
Distance
Default settings are underlined.
3
Use ui to select a speaker, and use
o p to select distance.
FL / FR / C / SW / SL / SR / SBLz / SBRz
Select the speaker.
zWhen the “Speaker Confi g.” – “S.B(Pre)”
(vpage 7) setting is set to “None”,
“SBL” and “SBR” is not displayed.
• 0.00m – 18.00m : Set the distance.
• The speakers that can be selected differ
depending on the “Speaker Confi g.” (vpage7)
settings.
• Default settings :
FL / FR / C / SW : 3.6 m
SL / SR / SBL / SBR : 3.0 m
• Set the difference in the distance between the
speakers to less than 6.0 m.
NOTE
Speakers set to “None” in “Speaker Confi g.”
(vpage7) are not displayed.
4
Press ENTER to enter the setting.
Distance
1.AVR1311E2ENG3rd100617.inddSec:81.AVR1311E2ENG3rd100617.inddSec:8 2010/06/1718:24:102010/06/1718:24:10
To Next Page
Loading...
Need help?
General
