DeWalt DCH273P2 Manual

4
English
WARNING: ALWAYS wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product may
contribute to hearingloss.
WARNING: ALWAYS use eye protection. All users and
bystanders must wear eye protection that conforms to ANSI Z87.1.
CAUTION: When not in use, place tool on its side on a stable
surface where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery
pack but may be easily knockedover.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ...................volts A ...................... amperes
Hz ................. hertz W ..................... watts
min ............... minutes or AC ..........alternating
or DC ... direct current current
................. Class I Construction or AC/DC ... alternating
(grounded) ........................or direct
................. Class II Construction current
(double insulated)
n
o ....................no load
…/min .......... per minute speed
BPM ............. beats per minute n ......................rated
IPM ............... impacts per minute ........................speed
RPM ............. revolutions per .....................earthing
minute terminal
sfpm ............. surface feet ..................... safety alert
..................... per minute symbol
SPM .............strokes per minute ....................visible
..................... .........................radiation
WARNING: ALWAYS use safety glasses. Everyday eyeglasses are
NOT safety glasses. Also use face or dust mask if cutting operation
is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratoryprotection.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treatedlumber.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopicparticles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap
and water. Allowing dust to get into your mouth, eyes, or lay on
the skin may promote absorption of harmfulchemicals.
WARNING: Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
andbody.

DeWalt DCH273P2 Specifications

General

Brand	DeWalt
Model	DCH273P2
Category	Rotary Hammer
Language	English