DeWalt DWE7491 User Manual

22
ENGLISH
In case workpiece fragments are jammed between saw blade
and guards, disconnect the machine from the power supply
and follow the instructions given in section Mounting the
saw blade. Remove the jammed parts and reassemble the
sawblade.
Keep the ventilation slots clear and regularly clean the housing
with a softcloth.
Regularly clean the dust collection system:
1. Unplug thesaw.
2. Turn the saw on its side, so the bottom, open part of the
unit isaccessible.
3. Open the dust access door
44
shown in FigureS loosening
the two screws and then by pressing the side clips
45
toward each other. Clean out the excess dust, and re-secure
by pushing the side clips completely into place then
tightening the lockscrews.
Optional Accessories

WARNING: Since accessories, other than those offered
by
DeWALT
, have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only
DeWALT
recommended
accessories should be used with thisproduct.
Consult your dealer for further information on the
appropriateaccessories.
Replace blade guard when worn. Contact your local
DeWALT
service centre for details on a blade guardreplacment.
SAW BLADES: ALWAYS USE 254 mm noise reduced saw blades
with 16 mm arbour holes. Blade speed rating must be at least
5000 RPM. Never use a smaller diameter blade. It will not be
guarded properly.
BLADE DESCRIPTIONS
APPLICATION DIAMETER TEETH
Construction Saw Blades(fast rip)
General Purpose 254 mm 24
Fine Crosscuts 254 mm 40
Woodworking Saw Blades (provide smooth, clean cuts)
Fine crosscuts 254 mm 60
Consult your dealer for further information on the
appropriateaccessories.
• DWE74911 Rolling Table Saw Stand
• DWE74912 Scissor Leg Stand
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
householdwaste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.

DeWalt DWE7491 Specifications

General

Idle speed	3800 RPM
Sound power level	106 dB
Angle setting range	-3 - 48 °
Sound pressure level	95 dB
Cutting height @ 45°	57 mm
Cutting height @ 90°	77 mm
Saw blade included	Yes
Number of saw blades	1
Input power	2000 W
Product color	Multicolor
Placement supported	Freestanding

Weight and Dimensions

Depth	742 mm
Width	577 mm
Height	425 mm
Weight	26600 g
Bore diameter	30 mm
Blade diameter	250 mm
Base plate depth	630 mm
Base plate width	670 mm