A machine should not be allowed to
operated if any of the following occur:
• Excessively high water level.
• Machine is not connected to a properly grounded
circuit.
• Loading door does not remain securely locked
during the entire cycle.
• Vibration or shaking from an inadequate mounting or
foundation.
Table of Contents
Section 1:
Machine Mounting & Installation
T-300 .....................................................................6
T-400 & T-600 .......................................................7
T-900 & T-1200......................................................8
T-300 Installation ...................................................9
T-400 Installation .................................................10
T-600 Installation ................................................. 11
T-900 Installation .................................................12
T-1200 Installation ...............................................13
Section 2:
Machine Installation & Operating Instructions
Basic Installation..................................................17
Electrical Connections & Fusing Requirements . . 18
Emergency Stop Button ......................................19
Detergent Measurements by Model ....................20
Machine Operating Instructions ................. 20 & 21
Section 3:
Machine Programming Instructions
Programming Instructions & Price Programming
............................................................. 24 & 25
Water Temperature Pricing ........................ 25 & 26
Wash Cycle
Programming .............................................. 26 & 27
Coin Washer Cycle Parameter Ranges ..............28
Coin Washer Default Cycle &
Rapid Advance Mode ...................................29
Section 4:
Trouble Shooting
Common Troubleshooting Solutions Pages ...32-36
Troubleshooting Machine Fault
Errors Pages ...........................................37- 41
Variable Frequency Drive Control
Digital Readout Faults ..................................42
Section 5:
Machine Service Procedures
Coin Drop Acceptor .............................................44
Lower Service Panel Removal ............................45
Dexter Safety
Guidelines
FOR SAFETY
Always shut off power and water supply 1.
and also discharge capacitors before
servicing.
Do not overload the washer.2.
Do not attempt to open door if cylinder 3.
is in motion or contains water.
Do not mechanically force or override 4.
door lock in any way.
Do not bypass any safety devices of 5.
this washer.
Do not use volatile or ammable 6.
substances in or near this washer.
Keep all panels in place. They protect 7.
against shock and injury and add
rigidity to the washer.
To activate your warranty, be sure to return
your red warranty form to the factory.
Please have serial number and model
ready when calling for assistance.
WARNING
These washers are equipped with devices and
features relating to their safe operation. To avoid
injury or electrical shock, do not perform and
service, unless qualied to do so.
2
Part # 8533-053-001 REV 4/09
To Next Page
Need help?
General
