A. To bypass eects, press the active 1-5 footswitch. The display will read “BYPASS”.
B. To exit Bypass mode, press the active 1-5 footswitch again.
C. To use the Tuner, press and hold the active 1-5 footswitch for 2 seconds. The display will
briey read “TUNER” then enter Tuner mode.
D. Play a note on
the guitar. The
note will be
shown in the
display and
arrows in the
display will
indicate if the
note is sharp,
at, or in tune.
E. To exit Tuner
mode, press
any of the 1-10
footswitches.
MAKING CONNECTIONS / APPLYING POWER BYPASSING EFFECTS & USING THE TUNER
WHAT’S IN THE BOX
• RP1000 Multi-Eects Switching System & USB Recording Interface
• Power Supply
REGISTER YOUR PRODUCT
To activate your warranty, please register at
http://digitech.com/en-US/support/warranty_registration.
GET X-EDIT
To get the X-Edit software, visit
http://digitech.com/en-US/products/RP1000#downloads.
GET THE OWNER’S MANUAL
Scan the QR code to get the owner’s manual or visit
http://digitech.com/en-US/products/RP1000#documentation.
1 2
Live Application Recording / Practice Application
A. Set your amp(s) to a clean tone, set the
tone controls for a at EQ response
(on most amps, this would be 0 or 5
on the tone controls), turn the volume
control(s) all the way down, then power
o the amp(s). If connecting to a mixer,
fully lower the corresponding channel
fader(s).
B. Make connections as shown in the
diagrams to the right, depending on
application type.
C. Connect the included power supply to
the POWER input jack and plug it into
an available AC outlet.
D. Set the RP1000’s MASTER LEVEL
control to 30.
E. Power on your amp(s). slowly raise the
amp volume control(s) for the desired
volume. If using a mixer, adjust each
channel’s gain/trim and fader controls
for the desired volume.
Press for Bypass, hold for Tuner
E
Sharp
In Tune
Flat
To Next Page
Need help?
General