MIDI Continuous Control
he Whammy™ is capable of remotely adjusting the treadle position, as well as turning the
Whammy™ effect on and off through the use of MIDI continuous control commands.
MIDI CC11 adjusts the treadle position.A value of 0 on MIDI CC11 corresponds to a toe up
osition and 127 corresponds to a toe down position.
MIDI CC0 is used to turn on and off the Whammy effect.Values from 0 through 64 on MIDI
CC0 will turn the Whammy™ effect off, and values from 65 through 127 will turn the effect on.
Calibrating the Treadle
n the unlikely event that the treadle pedal does not respond properly, or that the note does not
end or return to the correct pitch, it may need to be recalibrated.The following steps outline
he procedure for treadle recalibration:
. Disconnect the power from the Whammy™ pedal.
. Press and hold the footswitch down while reconnecting the power. One of the preset LEDs
will blink indicating that you are in set up mode.
. Rock the treadle fully forward and fully back.
. Press the footswitch again to exit the set up mode.
his completes the treadle calibration procedure.
User’s Guide
To Next Page
Loading...
Need help?
General
