CRX50, CRX65 Safety instructions
13
2.2 Operating the device safely
!
WARNING!
Failure to obey these warnings could result in death or serious injury.
DANGER OF ELECTROCUTION
• Do not touch exposed cables with your bare hands.
!
CAUTION!
Failure to obey these cautions could result in minor or moderate injury.
HEALTH HAZARD
• Make sure that no food comes into contact with the battery acid.
A
NOTICE!
DANGER OF DAMAGE
• Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for that purpose.
• Do not place it near naked flames or other heat sources (heaters, direct
sunlight, gas ovens etc.)
• Danger of overheating!
Ensure at all times that there is a minimum of 50 mm (2") ventilation on
all four sides of the cooling device. Keep the ventilation area free of
any objects that could restrict the air flow to the cooling components.
Do not place the cooling device in closed compartments or areas with
none or minimal air flow.
• Ensure that the ventilation vents are not covered.
• Do not fill the inner container with ice or fluid.
• Never immerse the cooling device in water.
• Protect the cooling device and the cable against heat and moisture.
• The use of a load dump board is mandatory on all Semi Truck
12 V or 24 V DC applications. Ensure that the load dump board and
the control module are always replaced together.
CRX50-65-Truck-IO-US.book Seite 13 Donnerstag, 18. Oktober 2018 3:51 15
To Next Page
Loading...
Need help?
General
