SaneoB, SaneoC Using the toilet
21
✓ The cassette tank lock locks by itself upon being pushed in.
➤ Check that the cassette tank is securely installed.
➤ Close and lock the service door.
6.3 Filling the freshwater tank
➤ Fill the freshwater tank through the filler neck on the outside of the vehicle. The
amount depends on the tank used (the integrated tank for models Saneo BW and
Saneo CW = 7 litres).
6.4 Using the toilet
The toilet seat is secured against falling in the open 90° position. With models with
Autoclose, the seat lowers slowly when triggered (fig. 7, page 4).
I
➤ Before use, press the flush button to wet the surface of the bowl. A flushing
operation is limited to 20 seconds regardless of how long the button is pressed.
You may be able to hear the relay switching.
➤ Pull the slider (fig. 8, page 4) forward. Leave the slider open during use.
➤ After use, press the flush button to rinse the bowl again.
➤ Close the slider (fig. 9, page 4).
When closing the slider, slight resistance can be felt from a distance of about
10 mm from the housing. The slider is closed when the slider handle is flush with
the toilet housing (fig. 9, page 4). Otherwise the cassette tank cannot be
removed.
The cassette tank has a capacity of 16 l. When the indicator lights up, the toilet
can only be use a few more times.
I
NOTE
The slider must be closed while driving, and no liquid should be above
the slider.
NOTE
With a 3/4-filled cassette, use is only possible when the slider is open.
With a tilted position (such as lasting inclination of the vehicle), the
cassette may only be 3/4 full. Overflowing through the vent is possible.
Saneo-B-Saneo-C--O-5s.book Seite 21 Mittwoch, 7. März 2018 9:45 09
To Next Page
Loading...
Need help?
General