microplus / microclick - transmitters
Interference Information
This equipment may interfere with radio communications, AM/FM radio and TV
reception. Use the following suggestions to correct the interference:
• Relocate the receiving antenna.
• Increase the space between the equipment and transmitter receiver.
• Connect the equipment into another outlet, different from the transmitter
receiver.
• Consult a technician for help.
This equipment has been certified to comply with the limits for a class B comput-
ing device, pursuant to FCC Rules. To maintain compliance with FCC regulations,
shielded cables must be used with this equipment. Operation with non-approved
equipment or unshielded cables may result in interference to radio and TV recep-
tion.
This Class [B] digital apparatus meets all requirements of the Canadian Interfer-
ence-Causing Equipment Regulations. Cet appareil numrique de la classe [B] re-
specte toutesles exigences du Reglement sur le materiel brouilleur du Canada.
FCC Compliance
This device will provide reliable remote access control. Be aware of the following
limitations:
• This device complies with FCC Rules and Regulations, Part 15 and Canadian In-
terference Causing Equipment Regulations. Because of this, they have limited
transmitter power and limited range. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, (2) this device
must accept any interference received, including interference that may cause
undesired operation.
• The receiving device cannot respond to more than one transmitted signal at a
time. Radio signals near the receiver operating frequency may block the trans-
mitter signal regardless of the code setting. If this occurs, the radio receiver
may have to be repositioned.
• Any changes or modifications may void compliance with FCC Rules and Regula-
tions.
DoorKing’s transmitters are ideal for applications that require
RF wireless access. Users can remain comfortably inside their
vehicle while activating the RF transmitter without having to
use a keypad or card reader. When activated a data stream is
sent to the remote SuperHet receiver. This data includes the
transmitter serial number, facility code, and button code. In
addition MicroPLUS transmitters have an encrypted sync-
code that changes each time the transmitter is used.
To Next Page
Need help?
General
