EN
STL-G/STL-G NT
Mounting instructions
WN 059727 45532/15191
2020-07
1 About this document
1.1 Contents and purpose
This document describes the mounting of the
STL-G door terminal with a profile cylinder and the
connection to a SafeRoute® system.
1.2 Target group
This document is intended for assembling technicians
and specialists authorized to carry out installation by
dormakaba.
1.3 Other applicable documents:
The following documents belong to the unit’s
complete documentation and must be observed:
• The optional accessory components’ assembly
instructions and documents
• The SafeRoute® system manual
• The respective door unit’s inspection log
• The approved components’ declaration of
conformity
1.4 Documents storage
This document must be handed over to the facility
operator after mounting and commissioning.
1.5 Symbols used
1.5.1 Hazard categories
WARNING
This signal word indicates a possible
hazardous situation which may result in
death or serious injury if not averted.
1.5.2 More symbols
1. 2.
Sequence of action steps
6
Reference to a chapter
Components may be damaged by
electrostatic discharge. Ground
your own body before touching a
component!
2 Safety
2.1 Intended use
The STL-G is a door terminal for operating and/or
controlling dormakaba's SafeRoute® electrical locking
system.
2.2 Personnel qualification
Mounting may only be carried out by persons
authorized by dormakaba.
Contents
1 About this document 1
2 Safety 1
3 Product description 2
4 Mounting 4
5 Disassembly, recycling and disposal 12
To Next Page
Need help?
General
