PC1404
Wiring Trikdis GT+ Cellular Communicator and
Programming the Panel
• The communicator should be installed and maintained by qualified personnel.
• Prior to installation, it is advised to read full device installation manual carefully in order to
avoid mistakes that can lead to malfunction or even damage the equipment.
• Disconnect the power supply before making any electrical connections.
• Changes, modifications or repairs not authorized by the manufacturer shall void your rights
under the warranty.
CAUTION
Schematics forwiring the communicator
to the security control panel
Following the schematics provided below, wire the communicator to the control panel.
trikdis.com
DSC PC1404
EGND
T-1
R-1
Z4 Z2
COM COM GRN YEL
AUX
- +
AC
-BELL+
PGM
2
1
Z3 Z1
TIP
RING
To Next Page
Need help?
General
