Ducati 999 User Manual

70
E
Chain tension inspection (fig. 64)
Important
Have the drive chain tensioned up at a Ducati
Dealer or Authorized Workshop.
With the motorcycle on the side stand, use your finger to
press down the chain lower section. Then release and
measure distance between surface (A) and pivot centre
below. The reading should be 30-35 mm.
Warning
Correct tightening of the tensioner lock nuts (1) is
essential to rider and pillion passenger’s safety.
Important
Improper chain tension will lead to early wear of
transmission parts.
Chain lubrication
The chain fitted on your motorcycle has O-rings that keep
dirt out of and lubricant inside the sliding parts. The seals
might be irreparably damaged if the chain is cleaned
using any solvent other than those specific for O-ring
chains or washed using steam or water jets. After
cleaning, blow the chain dry or dry it using absorbent
material and lubricate with SHELL Advance Chain or
Advance Teflon Chain on each link.
30 ÷ 35 mm
1
A
fig. 64
Important
Using non-specific lubricants may lead to severe
damage to chain, front and rear sprocket.

Ducati 999 Specifications

General

Compression Ratio	11.4:1
Transmission	6-speed
Fuel Tank Capacity	15.5 l (4.1 US gal)
Rear Suspension	Progressive linkage with fully adjustable Showa monoshock
Front Brakes	2 x 320 mm discs, 4-piston calipers
Rear Brakes	240 mm disc, 2-piston caliper
Tire Front	120/70 ZR 17
Tire Rear	190/50 ZR 17
Engine Type	L-Twin cylinder, 4 valves per cylinder Desmodromic
Bore x Stroke	100 mm x 63.5 mm
Power	104 kW (141 hp) @ 9750 rpm
Torque	110 Nm (81.4 lb-ft) @ 8000 rpm
Front Suspension	Showa 43 mm upside-down fork, fully adjustable