50 LB Ice Melt
Spreader
MODEL # 90950 ASSEMBLY INSTRUCTIONS
90950 – 50lb Ice Melt Spreader PAGE 1
ASSEMBLY
STEP 1:
Remove spreader from carton and
pull handle into
position shown at right. Tighten
wingnuts to secure.
STEP 2: Install CONTROL ROD into handle as shown
above. TIP: Install the CONTROL ROD using pliers to
squeeze into LEVER.
STEP 3: ROTATE FORWARD Insert CONTROL ROD into
pivot at bottom of hopper and secure with hair pin
clip (Shown to the right.)
Thank you for selecting
EarthWay for your
spreader needs. Our
production team in
Northern Indiana takes
pride in building this
spreader. spreader. Our customer support team is
standing ready to ensure your success. Please
contact us at www.EarthWay.com to see our full
line of commercial, lawn & garden tools.
NOTE: The large opening is designed to allow ice
melt to flow through spreader without the need
for an agitator. This unit is not designed for
fertilizer.
For spreading
fertilizer, please
select the right
spreader.
To Next Page
Need help?
General
