GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
23
A
B
C
D
1. Disconnect spark plug lead from spark plug.
2. Release stored energy in power spring by removing spark plug.
3. Remove three (3) screws (A) from starter assembly and remove
starter.
NOTE
DO NOT disassemble the starter assembly.
4. Remove the four screws that retain the engine cover. Two at the
inside top of the mounting plate (B), one on the top guard (C), and
one at the muffler cover (D).
5. Disengage the heat deflector tabs (E) under the muffler from the
slots in the engine/muffler cover.
6. Lift the cover from the engine.
7. Reinstall spark plug and starter assembly to prevent dirt and debris
from entering engine and starter.
NOTE
When installing starter housing to mounting body, be sure that
drive starter cam engages the starter pawls correctly.
E
D
To Next Page
Loading...
Need help?
General