EDIFIER X2s User Manual

EN 1. Power ON/OFF
2. Pairing
3. Reset
4. Left & Right connection
6. Controls
True Wireless Earbuds Headphones
X2s
Manual
1. Taken out of the case.
2. Disconnected from any Bluetooth device. Press and hold the touch
panel on either earbud for around 8s until blue LED blinks 6 times
to clear the Bluetooth pairing records and power o. If the left and
right earbuds are connected, the other side will clear the
Bluetooth pairing record and power o too.
3. Placed back in the case and taken out of the case again.
4. Select "EDIFIER X2s" in your Bluetooth device setting to connect.
White LED will blink twice in 5 seconds when successfully.
1. When earbuds are powered on and there is no Bluetooth connection
and TWS connection, respectively tap the touch panel 5 times on
both earbuds until white LED blinks slowly to enter TWS pairing
mode. Once the left and right earbuds are connected successfully,
white and blue LEDs will blink alternately to enter Bluetooth
pairing mode.
2. Select "EDIFIER X2s" in your Bluetooth device setting to connect.
White LED will blink twice in 5 seconds when successfully.
1st Pairing
1. Taken out of the case. White and blue LEDs will blink alternately.
2. Select "EDIFIER X2s" in your Bluetooth device setting to connect.
White LED will blink twice in 5 seconds when successfully.
Note:
For subsequent use, the earbuds will automatically connect to the
device used last time.
Note:
1. Images are for illustrative purposes only and may dier from the
actual product.
2. Download Edier Connect App for more customizable control
settings.
For more information, please visit our website:
www.edier.com
@Edier_Global @Edier_Global@Edierglobal
Model: EDF200123
Edier International Limited
P.O. Box 6264
General Post Oce
Hong Kong
www.edier.com
2023 Edier International Limited. All rights reseed.
Printed in China
NOTICE:
For the need of technical improvement and system upgrade,
information contained herein may be subject to change from time
to time without prior notice.
Products of EDIFIER will be customized for dierent applications.
Pictures and illustrations shown on this manual may be slightly
dierent from actual product. If any dierence is found, the actual
product prevails.
1. Power ON when taken out of the case.
2. Power OFF when placed in the case.
Note:
If there is no Bluetooth connection for 10 minutes after powered on,
the earbuds will power o automatically.
White LED lit for 1s
Indicator Indicator
8s 8s
Indicator
Left Touch Panel Right Touch Panel
Earbuds
1. When hearing a low batte prompt tone, please
place the earbuds in the case for charging.
2. White LED on earbud is steady lit when charging
and o when fully charged.
Charging Case
1. Please connect the case to power source with
the included Type-C charging cable for charging.
2. White LED is steady lit when charging and o
when fully charged.
Note:
Please do not charge the earbuds when there is
sweat or other liquids inside the charging po,
which may damage the earbuds.
Input: 5V 200mA(Earbuds)
5V 1A(Charging case)
Indicator Indicator
x5 x5
Indicator Indicator
5. Charging
x2x2
x2x2
x3x3
2s2s
2s
2s
x2x2

EDIFIER X2s Specifications

General

Brand	EDIFIER
Model	X2s
Category	Headphone
Language	English