EINHELL GC-PM 46 User Manual

GB
- 20 -
Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Explanation of the warning signs on the
equipment (see Fig. 13)
1) Read the operating instructions.
2) Take care of the danger from catapulted
parts. Keep a safe distance.
3) Danger! Sharp blades - Switch off the engine
and pull the spark plug boot before doing any
maintenance, repair, cleaning or adjustment
work.
4) Fill with oil and fuel before starting the mower.
5) Caution: Wear ear protection and safety gog
gles.
6) Guaranteed sound power level.
7) Caution! Hot parts. Keep your distance.
8) Fill in fuel only when the engine is switched
off .
9) Risk of cut injuries. Caution: rotating cutters.
10) Starting procedure
11) Engine start/stop lever (I=Engine on; 0=Engi-
ne off )
2. Layout and items supplied
2.1 Layout (Fig. 1-11)
1a. Engine start/stop lever (engine brake)
2. Fuel pump (primer)
3. Top and bottom push bar
4a. Debris bag
4b. Level indicator
5a. Ejector fl ap
5b. V-belt
6. Tank fi ller cap
7. Oil fi ller screw
8. Cutting height adjustment
9. Starter cable
10. 1x cable clip
11. Star nut (2x)
12. Long screw (2x)
13. Spark plug wrench
14. 2x screws (hex, bottom push bar)
15. 2x screws (countersunk, bottom push bar)
16. 4x nuts (bottom push bar)
17. Eyelet
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Anl_GC_PM_46_SPK7.indb 20Anl_GC_PM_46_SPK7.indb 20 05.08.2019 10:40:1005.08.2019 10:40:10

EINHELL GC-PM 46 Specifications

General

Type	Push lawn mower
Motor type	Single cylinder OHV
Cooling type	Air
Cutting width	460 mm
Grass catcher	Yes
Cutting height	30 - 80 mm
Cutting system	-
Number of wheels	4 wheel(s)
Rotational speed	3000 RPM
Sound power level	96 dB
Fuel tank capacity	1.3 L
Handle(s) features	Adjustable, Ergonomic
Engine displacement	139 cm³
Rear wheels diameter	204 mm
Sound pressure level	80.7 dB
Front wheels diameter	177.8 mm
Recommended lawn area	1200 m²
Maximum cutting height	80 mm
Minimum cutting height	30 mm
Grass collecting volume	50 L
Engine number of strokes	4
Cutting clearance adjustment	9
Power source	Gasoline

Weight and Dimensions

Weight	28000 g
Package depth	775 mm
Package width	530 mm
Package height	440 mm
Package weight	32000 g