Elitech RC-4 Quick Start Guide

Quick Start Guide
RC-4/RC-4HA/RC-4HC
Soware download: www.elitechlog.com/sowares
Install Battery Install Software
1.Please visit www.elitechlog.com/sowares. Select
and download the soware.
2.Double click to open the zip file. Follow the
prompts to install it.
3.When the installaon is completed, the ElitechLog
soware will be ready to use.
Please disable the firewall or close the anvirus
soware if necessary.
Troubleshooting
Start/Stop Logger
1.Connect the logger to a computer to sync the
logger me or configure parameters as needed.
2.
Press and hold to start the logger unl
shows. The logger starts logging.
3.Press and release to shi between display
interfaces.
4.Press and hold to stop the logger unl
shows. The logger stops logging.
Please note all the recorded data cannot be
changed for security reasons.
1
2
4
Configure Software
3
1.Download Data: ElitechLog soware will automacally
access the logger and download the recorded data
to local computer if it finds the logger is connected.
If not, manually click “Download Data” to download
the data.
2.Filter Data: Click “Filter Data” under Graph tab to
select and view your desired me range of the
data.
3.Export data: Click “Export Data” to save Excel/PDF
format files to local computer.
4.Configure opons: Set logger me, log interval,
start delay, high/low limit, date / me format, email
etc. (Check User Manual for default parameters).
Note: New configuraon will inialize previous
recorded data. Please make sure to back up all
necessary data before you apply new
configuraons.
Refer to “Help” for more advanced funcons. More
product informaon are available on the company
website www.elitechlog.com.
If...
Please...
only a few data was logged.
check whether the baery is installed; or check if it was installed correctly.
the logger does not log aer start up the logger cannot stop logging by pressing the buon .
check whether start delay is enabled in the soware configuraon.
check parameter sengs to see if buon customizaon is enabled (default configuraon is disabled.)
1.Use a proper tool (such as a coin) to loosen the
baery cover.
2.Install the baery with “+” side upward and keep
it under the metal connector.
3.Put the cover back and ghten the cover.
Note: Do not remove the baery when the logger
is running. Please change it when necessary.
ＣＲ２４５０

Elitech RC-4 Specifications

General

Brand	Elitech
Model	RC-4
Category	Other
Language	English