12
WARNING:The base of the appliance should be protected from contact by a horizontal partition or
plate.
A manual valve be installed in an accessible location in the gas line external to the appliance for the
purpose of turning on or shutting off gas to the appliance.
Warning：Turn the knob counterclockwise to adjust the flame, size,so that the flame does not float out of
the container rim.
If need to adjust the flame size from big to small when operation, turn the knob counterclockwise 90
degrees to the position. (See Figure 13)
Figure 13
When you need to change the gas cooktop, you must first close the air supply valve and the cooktop
valve, unplug the plug of models with AC power supply, only after that you can remove the connector
hose or threaded connector and then move the gas cooktop.
Warn of the potential hazards associated with storage cabinet areas above appliances. Misoperation
can cause fire.
All cord connected appliances shall include instructions relative to location of the wall receptacle and a
warning to the user to disconnect the electrical supply before servicing the appliance. Socket needs to
be installed below the cooktop surface, and away from the fire source
Gas Conversion Operating Instructions
To Next Page
Loading...
Need help?
General
