Wireless Call Point
Installation Guide
©2018 EMS Ltd. All rights reserved Page 1 of 2 TSD005 Iss 12 25/07/2018 AJM
1 Pre Installation
4 Power Device
When fitting / replacing batteries; observe correct polarity,
using only specified batteries.
Connect the power jumper across the PIN header.
3 Fix Mounting Plate
2 Components
Part No Product Description
!
Installation must conform to applicable local installation
codes and
should only be installed by a fully trained
competent person.
Ensure that the device is installed as per the site survey.
The use of a non-metallic spacer should be considered if
mounting the device on to a metal surface.
Do NOT Press the Log On button on a pre-programmed device,
as this will cause communication with the Control Panel to be
lost. Should this happen, delete the device from the system and
add it back on.
Fixing Screw
Mounting Plate
Remove the mounting plate from the wireless call point. See
Step 5 for more information on unlocking the device.
5 Device Locking
6 Configuration
When reassembling, observe
the hinged connection
located on the devices top
edge first, prior to closing
the unit. Finally lock the call
point into the mounting
plate by tightening the fixing
screw.
Use both mounting holes.
Use suitable fasteners and fixings.
Once powered, reassemble the device.
The device’s loop address is configured within the menu structure
of the Radio Hub.
Refer to the programming manual (Doc Ref: MK98) for full
programming information.
Free to download from
www.emsgroup.co.uk
FC-200-002 Wireless Call Point
5-5201/EN54 Replacement Elements
Wireless Call Point
57mm
67mm
device
unpowered
(pins unlinked)
device
powered
(both pins linked)
SIZE AA
SIZE AA
SIZE AA
SIZE AA
SIZE AA
SIZE AA
Fixing screw
bottom view
of device
To open the call point,
loosen the fixing screw, then
slide the call point up, away
from the mounting plate.
2
3
1
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
1
2
3
Ensure mounting plate is fitted in the orientation shown.
4
Protective Cover
4
To Next Page
Need help?
General
