Epson PowerLite 84 Installation Handbook

INSTALLATION
HANDBOOK
Lamp and Status Information
Epson PowerLite 84
Replacing the Lamp
The life span of the projection lamp is about 5000 hours if
Brightness Control in the Setting menu is set to High (default), and
6000 hours if
Brightness Control is set to Low.
It is time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
The message Replace the lamp appears on the screen when the
lamp comes on and the lamp warning light ashes orange. To
maintain projector brightness and image quality, replace the lamp
as soon as possible.
The lamp warning light ashes red (the lamp is burnt out).
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766). Request part number V13H010L50.
Replacing the Lamp
1. Turn o the projector.
2. When the P power light stops ashing, unplug the power cord.
3. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
4. Loosen the lamp cover screw (you can’t remove it). Then slide the
lamp cover and lift it o of the projector.

Epson PowerLite 84 Specifications

General

Projection technology	LCD
Contrast ratio (typical)	2000:1
Projector native resolution	XGA (1024x768)
Aspect ratio	4:3
Dimensions (WxDxH)	327.6 x 248.9 x 93.9 mm
Power requirements	100-240VAC +/-10%, 50/60Hz AC
Lamp type	UHE
Lamp power	200 W
Light source type	Lamp
Service life of light source	5000 h
Service life of light source (economic mode)	6000 h
Focal length range	18.2 - 29.2 mm
RMS rated power	10 W
Number of built-in speakers	1
Microphone in	Yes
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in	2
Power consumption (typical)	289 W
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Weight	3100 g