Start Here
3 Squeeze the edge guide as you slide it all the way to the
left.
4 Load letter or A4-size paper against the right edge and
behind the tab, with the printable side face up.
5 Slide the edge guide over.
Read these instructions before using your product.
1
Unpack
Power cord USB cable
Caution: Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1 Connect the power cable.
Caution: Do not connect to your computer yet.
2 Press the Encender (On) button.
3
Select language
The default language of the LCD panel screens is Spanish.
To select Spanish as your language, press
Iniciar (Start).
Note: If you want to change the language, press or to select
it, then press
Iniciar (Start).
4
Install ink cartridges
Caution: keep ink cartridges out of the reach of children and don’t
drink the ink.
Note: The ink cartridges included with your product have a lower
yield due to the ink charging process. This process is carried out
the first time the product is turned on and guarantees a better
performance.
Do not load paper yet.
1 Lift up the scanner, then open the cartridge cover.
2 Shake the ink cartridges gently 4 or 5 times, then unpack
them.
3 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals or the cartridges may
leak.
4 Insert the cartridges in the holder for each color.
5 Press each cartridge down until it clicks.
6 Close the cartridge cover. Press down until it clicks.
7 Lower the scanner.
8 Press the Iniciar (Start) button to charge the ink.
Priming takes about 2 minutes.
Caution: Don’t turn off the printer while it is priming or you’ll
waste ink.
5
Load paper
1 Open the paper support and pull up the extensions.
2 Open the output tray, pull out the extensions, and raise
the stopper.
*411847000*
*411847000*
Epson Stylus
®
TX220
4118470 Rev.0
1-F C
4118470 Rev.0
1-F M
4118470 Rev.0
1-F Y
4118470 Rev.0
1-F K
To Next Page
Need help?
General