How to connect an Epson POS printer with Ethernet Interface
http://www.beaglehardware.com/howtoethernet.html[3/4/2011 12:27:20 PM]
This will open up the Add Standard TCP/IP Printer Port Wizard.
Enter the IP address of the Ethernet adapter (192.168.2.29 shown here). The utility will then locate the printer on the
Ethernet network and create the port. This port (IP_...) will now be selected fro use with this printer.
You may need to make a few changes in the printer settings to get it to work with the Ethernet adapter. Specifically you
need to configure the port you are using. Open the printer in the Windows Printer Folder. Select the Ports Tab. Select the
Ethernet port in use (i.e. IP_). Also turn off
bidirectional support, if enabled.
To Next Page
Loading...
Need help?
General