INSTRUCTIONS for
F-12-778-H
June, 1999
MT-200, MT-400 & MT-400EHD*
MIG WELDING GUN
WITH BAYONET CONNECTOR
Be sure this information reaches the operator.
You can get extra copies through your supplier.
These INSTRUCTIONS are for experienced operators. If you are not fully familiar with the principles of operation
and safe practices for arc welding equipment, we urge you to read our booklet, "Precautions and Safe Practices for
Arc Welding, Cutting and Gouging." Form 52-529. Do NOT permit untrained persons to install, operate, or maintain
this equipment. Do NOT attempt to install or operate this equipment until you have read and fully understand these
Instructions. If you do not fully understand these Instructions, contact your supplier for further information. Be
sure to read the Safety Precautions on page 3 before installing or operating this equipment.
*Extra Heavy Duty (EHD)
To Next Page
Need help?
General
