MODEL NUMBER
SERIAL NUMBER
DATE OF PURCHASE
Customer Pre-Operation Check List Reference
Read, understand and follow the general safety rules
listed in this manual.
Page 2
Check all shields and guards. Page 2
Cut driveshaft to the proper length for your tractor. Page 8
Add ballast to the rear tractor tires and space them six
feet or wider apart.
Page 8
Add ballast and front weights to your tractor, if needed. Page 8
The Hydraulic and operational System Setup. Page 9
Working safely with hydraulic lines. Page 10
Check all fluid levels, tractor and cutter. Page 11
Turn gate valve under the oil tank “on”. Page 12
Check all grease fittings. Page 15
Service Notice
Please take extra care while servicing the hydraulic system by keeping all openings
properly covered, thus preventing contamination of the hydraulic components.
Contaminates in the oil WILL cause faulty operation or premature failure of components in
the hydraulic control valve, pump, and motor.
Disclaimer
THIS CUTTER IS NOT DESIGNED TO CUT TREES FROM TOP TO BOTTOM (VERTICALLY) WITH THE
CUTTER DECK ON THE HORIZONTAL POSITION (SEE FIG. 1). The cutter is designed to trim branches with the
cutter deck in the VERTICAL position while moving the tractor forward or backwards, repositioning the cutter deck after
each path (see fig. 2).
Any modes of operation other than the ones described above and shown below, while cutting trees and/or branches are not
permitted and shall void the warranty. Moreover, HARDEE by EVH Manufacturing Company, LLC does not accept and
liability to any person and/or material when the cutter is operated in violation of the above information.
To Next Page
Loading...
Need help?
General
