the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions in the literature accompanying the product.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or
the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles and the
point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus.
When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from
tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been
dropped.
15. To completely disconnect this apparatus from the AC mains, disconnect the power supply cord plug from the
AC receptacle.
16. The mains plug of the power supply cord shall remain readily operable.
17. WARNING – To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
18. Do not expose this equipment to dripping or splashing and ensure that no objects filled with liquids, such as
vases, are placed on the equipment.
19. Maintain at least 6 inches (15.25 cm) of unobstructed air space behind the unit to allow for proper ventilation
and cooling of the unit.
20. CAUTION – For rack mounted power amplifiers, keep all wiring and materials away from the sides of the unit
and allow the unit to cool down for 2 minutes before pulling from a rack enclosure.
21. Amplifiers and loudspeaker systems, and ear/headphones (if equipped) are capable of producing very high
sound pressure levels which may cause temporary or permanent hearing damage. Use care when setting and
adjusting volume levels during use.
22. FCC COMPLIANCE NOTICE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not used in accordance with the instructions, may cause harmful interference to radio
communications and there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: reorient or relocate the receiving antenna, increase the separation between the equipment
and receiver, connect the equipment into an outlet on a circuit different from that of the receiver. Consult the
dealer or an experienced radio/TV technician if help is needed with interference. NOTE: FMIC will not be
responsible for unauthorized equipment modifications that could violate FCC rules, and/ or void product safety
To Next Page
Loading...
Need help?
General
