07-7
It can only function correctly if the
wiring and the connections in the base
vehicle have been carried out/alloca-
ted according to DIN 72570.
Separate equipment/rally
package
(available only as a special accessory or
model-specic)
If your camper has been tted with separate
equipment or the rally package by the manufac-
turer, please note the following:
In the nylon folder that contains the documents
for the vehicle you will also nd the following
operating instructions and connecting diagrams:
- manufacturer‘s operating instructions for the
multi-function electrical supply / charger
- manufacturer‘s operating instructions / user
information for the power supply battery
- manufacturer‘s operating instructions for the
gas / hot water tank (replaces standard hot
water heater)
- connecting diagram for the rally package
Please read these important documents carefully
to ensure that the rally package functions cor-
rectly and efciently.
If the rally package is installed the manufacturer,
a gel battery is always installed. Generally, you
will nd this battery in a separate box which, de-
pending on the layout of your camper, is located
in the storage space either under the seating
arrangement or the bed. This gel battery may not
be replaced by a conventional wet battery.
Use the board control to check the state of char-
ge of both the camper‘s battery as well as the
base vehicle‘s battery.
Position 1 is for the base vehicle, position 2 for
the camper‘s battery.
You will also nd the main switch for the rally
package on this control panel.
Switch off all devices and lights
before you disconnect the battery.
– Smoking is absolutely forbidden
when working on the battery or if the
battery container is open.
Please also note the label on the bat-
tery container.
To Next Page
Loading...
Need help?
General