11-3
Do not use aggressive cleaners or
cleaners which contain solvents.
Cleaning with a high-pressure cleaner
Note the instructions for the high-pressure
cleaner before washing the camper with it. Keep
a minimum distance of 700 mm between the
camper and the high-pressure nozzle. Note that
the water jet comes out of the cleaning nozzle
with a great deal of pressure. Incorrect use of the
high-pressure cleaner can damage the camper.
The temperature of the water must not exceed
60° C. Keep the water jet constantly moving
during the entire washing process. The water jet
must not be aimed directly at the clearance bet-
ween the door frame and door leaf or the win-
dow frame and window leaf, electrical add-ons,
pin-and-socket connectors, gaskets, sealing
grill for refrigerator or the roof bonnets. This can
damage the vehicle or allow water to seep into
the interior.
Never use a high-pressure cleaner to clean the
rear lights of the camper. The water can be spra-
yed under the rubber seal of the lamp and get
into the lamp compartment. This delays drying
time while increasing the danger of corrosion or
the formation of moss in the umes.
Rules for cleaning the exterior:
• Rinse the vehicle with a light stream of water.
• Wipe the vehicle down with a soft sponge and
typical shampoo solution.
Rinse the sponge often in the process.
• Afterwards, rinse with a great deal of water.
• Dry the vehicle with a suede cloth.
• Allow the vehicle to stand out in the open
after washing to let it dry.
Dry spotlight and lamp frames thor-
oughly, since water can build up in
these areas very easily.
Labels and exterior decorations
should not be sprayed directly with a
high-pressure cleaner, because they
may come off.
To Next Page
Loading...
Need help?
General