1 GE interface
The AN5506-01-A is an FTTH GPON optical network unit with high performance and low
power consumption. It provides subscribers with multicast services and enables their access
to Internet to cater for the broadband access demands of families. The AN5506-01-A
supports the functions as follows:
AN5506-01-A
Hang the equipment on the screws
5
Warranty Description
Indicates that this hazardous substance contained in all of the homogeneous materials
for this component is below the limit requirement in SJ/T11363-2006.
Indicates that this hazardous substance contained in at least one of the homogeneous
materials used in this component is above the limit in ST/T11363-2006.
The exterior components of this product are made of harmless, non-toxic, eco-friendly
materials. The non environment-friendly materials contained are due to the current
technological level limit, but they are rarely used in this product. Please feel at ease
using our product.
○：
×
：
Note:
Corollary equipment:
Some electronic components of the power adapter contain lead (Pb).
Table of Toxic / Hazardous Substances' Name and Concentration
Toxic / Hazardous Substance or Element
Cd
Cr6+
PBB PBDE
Component
Pb
Hg
X
Structual Component
Board / Circuit Template
Signal Wire
Corollary Equipment
For your lawful rights and interests, please notice:
1. The Warranty Card shall come into force with the seal of dealer.
2. Please keep this card properly. No reissuance will be provided if you lose it and it
becomes invalid if altered.
3. In the event of a non man-made malfunction during the warranty period, FiberHome will
repair or replace this product to its original operating condition free of charge.
Warranty does not cover the following circumstances:
1.Damage or malfunction caused by transporting, loading and unloading.
2.Damage or malfunction caused by man-made reasons such as opening or
remodel the machine on users' own.
3.Damage or malfunction caused by unsatisfactory environment.
4.Damage or malfunction caused by force majeure incidents (such as fire,
earthquake, lightning strike, war).
5.Damage or malfunction caused by failure to operate and maintain in
accordance with the user's manual
6.Damage of external parts such as equipment enclosure, power connector in
operation.
7.The inconsistence of the Warranty Card and the product serial number, or the
warranty card has been altered.
When you purchase a product offered by FiberHome from an authorized dealer, you
have a 12-month warranty as standard, except for man-made causes. The warranty
period begins on the date of invoice.
We provide paid repair and maintenance service for the products that are beyond the
warranty scope. The final explanation rights of this warranty description are reserved
by FiberHome.
Add: No. 88 Youkeyuan Rd., Wuhan, China
Zip code: 430074
Website: http//www.fiberhomegroup.com
Fiberhome Telecommunication Technologies Co.,Ltd
CERTIFICATION
CHECKER
DATE
are trademarks of FiberHome Telecommunication Technologies Co., Ltd.
(Hereinafer referred to as FiberHome)
All brand names and product names used in this document are used for
identification purposes only and are trademarks or registered trademarks
of their respective holders.
No part of this document (including the electronic version) may be
reproduced or transmitted in any form or by any means without prior
written permission from FiberHome.
Information in this document is subject to change without notice.
Fiberhome Telecommunication Technologies Co., Ltd.
All rights reserved.
2014
C
GPON
Optical Network Unit
User Manual
For a correct, safe use of the equipment, please read the following carefully and strictly observe the
operation safety rules during your operations.
Operation Safety Rules
Product Introduction
Product Type
Technical Specification
Description
Item
Type
Mechanical
parameter
Power supply
parameter
Power consumption
parameter
Environmental
parameter
DC
Power consumption
＜4W
Operating temperature
Storage temperature
Environmental humidity
-5 to 45℃ ℃
-40 to 70℃ ℃
10% to 95%, non-condensing
Dimension
Weight
120g approximately
25.5mm×112mm×112mm (H W D)× ×
The AN5506-01-A can be placed on a desk, or hung against the wall.
Desk top mounting
Equipment Installation
1
2
3
Drill holes
Mark installation
holes
Install expansion bolts
4
Install screws
75mm
3mm3mm
90
AN5506-01-A
Wall-hung mounting
Uses GPON uplink that is compliant with ITU-T G.984 series of standards;
Supports the configuration of Ethernet interface rates, working modes, MDI / MDIX auto-
negotiation mode, and Pause flow control;
Supports packet filtering and protection against illegal message attacks; supressess unknown
unicast, multicast and broadcast packets;
Provides performance statistics on all Ethernet lines;
Supports obtaining the user IP address in the DHCP mode, supports reporting the physical
position information of Ethernet interfaces through DHCP Option82;
Supports obtaining the user IP address in the PPPoE mode, supports the PPPoE+ function for
accurate user identification;
High optical power can cause bodily harm, especially to eyes. Never look directly into the end of the
optical transmitter fiber jumper or the end of its active connector.
Exercise care if you must bend fibers. If bends are necessary, the fiber bending radius should never
be less than 38mm.
Power socket overload, broken cables or broken plugs may cause electric shock or fire. Regular
check-ups on power supply wires and cables are essential. If any appears damaged, replace at once.
Use the power supply adapter provided in the package only. Using other adapters may cause
equipment damage or operation failures.
Install the equipment in a well ventilated environment without high temperatures or direct sunlight to
protect the equipment and its components from overheating, which can result in damage.
Power off the equipment in the event of lightning storms. Disconnect all cables connected to
the equipment such as power cable, network cable and telephone line to avoid equipment
damages caused by lightning stroke.
Avoid moisture, dampness and water damage. Equipment exposed to water cannot work normally
and can be extremely hazardous due to shorting.
Do not lay this equipment on an unsteady base.
Supports IGMP snooping protocol;
Supports the L2 / L3 wire speed forwarding;
Supports the NAT function;
Supports the WEB configuration function;
Supports the AES-128 algorithm for data encryption of downlink data;
Performs various QoS functions: supporting global configuration of queue priority and
flexible mapping of 802.1p value of packets;
Supports the PQ queue scheduling mode.
Code: MN000001958 Version: A
â
â
To Next Page
Need help?
General
