www. eldcontrols.com
Please retain these instructions after installation.
This device MUST be installed by a quali ed agency in accordance with the manufacturer's installation instructions. The de nition of
a quali ed agency is: any individual, rm, corporation or company which either in person or through a representative is engaged
in, and is responsible for, the installation and operation of HVAC appliances, who is experienced in such work, familiar with all the
precautions required, and has complied with all the requirements of the authority having jurisdiction.
READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION.
Installation Date:
Installed By: Phone:
P/N 46139100 Rev P 08/19
SIDEWALL POWER VENTER KIT
Model: SWG & SWG Stainless Series
*Patented
GENERAL SYSTEM INFORMATION
Designed for operation with natural gas, LP gas and #2 fuel oil appliances.
1. The thermostat (wall thermostat or aquastat) calls for heat and energizes a relay which activates the
power venter. After the venter motor has come up to speed, the pressure switch closes. This closes the
circuit to the burner and allows the burner to re.
2. For millivolt controlled water heaters using the CK-20 Series Control Kit, the gas valve pressure switch
activates the power venter at the same time as the burner res.
3. After the heating requirement has been satis ed, the thermostat circuit will open and de-activate the
burner and power venter circuit.
4. For venting systems equipped with a post purge device, the power venter operates for a period of time
after the burner has shut o to purge remaining ue gases.
CK series control kit
sold separately
TYPICAL VENTING SYSTEM COMPONENTS
1 - SWG Series Power Venter
1 - CK Series Control Kit (sold separately)
OPTIONAL SYSTEM COMPONENTS
SWG SERIES THROUGH-WALL EXTENSION KIT
For installation in wall thickness over 8 inches. Models PEK-4 through PEK-8 are available.
FOR MOST MULTIPLE HEATING EQUIPMENT SYSTEMS
One CK Series Control Kit for each appliance. Except for a 24V gas furnace or boiler and a 30mV
water heater multiple venting system, use the CK-90 Series Control Kit.
CONTENTS
Available Control Kits ....................................2 General Inspection ........................8
Installation Instructions ................................2 Maintenance ....................................9
Wiring .................................................................7 Repair Parts ...................................... 9
Air Flow Adjustments ....................................8 System Information .................... 12
To Next Page
Need help?
General
