6
USING LOOSE LEAF
Touch and glow. Place fingers on both touch
sensors to start heating.
The LED will blink green two times then turn
solid green. Solid green means it's ready. Watch for the glow!
Continue to hold the touch sensors while you
inhale for 10 seconds with a long, deep draw.
Release touch sensors to stop heating.
After a few draws, stir the contents of the
heating chamber.
For a denser vapor, inhale more deeply for a
few more seconds. To further customize vapor,
see the Tips and Tricks section later in this document.
VAPING LOOSE LEAF
IMPORTANT: Place fingers lightly on touch sensors (as if you
are tapping a smart-phone). Do not press down or use excessive
IMPORTANT: The Firefly will turn off after 30 seconds of holding the touch sensors, and the heating coil will not glow as bright towards the end of a vape session.
To Next Page
Loading...
Need help?
General
