EasyManuals Logo
Home>Firstech>Remote Control>FTX2400R-SS

Firstech FTX2400R-SS User Manual

Firstech FTX2400R-SS
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Advanced System Functions
This remote has the ability to operate a 2nd vehicle. Hold buttons for 2.5 seconds to activate this feature. The remote’s LEDs
will flash and change to red confirming that 2nd car mode is activated. The remote will remain in 2nd Car Mode until you hold the
buttons for 2.5 seconds again. The remote will beep twice and the LEDs change from red to blue to confirm 2nd car mode is off.
IMPORTANT: 2nd car mode requires the remote to be programmed to a 2nd vehicle that is equipped with the same remote kit.
R

c@m@Hm@v@cI
The optional Secure Valet Switch prevents the alarm from being put into valet mode through cycling the ignition on/off five times. The
Secure Valet Switch is more secure than traditional toggle / valet switches because it requires a two digit code. IMPORTANT: The first
two digits of the RPS unlock/disarm pass code will be the default pass code for the secure valet - you do not need to program them
independently. If you are not using the RPS unlock, following the below procedures to program your secure valet pass code;
STEP 1: Turn on Option 3-10-III. (Dealer programmed option)
STEP 2: Turn ignition key to the on position.
STEP 3: Hold down the valet switch for 1.5 seconds. The LED on the valet switch will begin to flash rapidly with successful completion of this step.
STEP 4: Enter the first digit of the desired two digit pass code by depressing the switch the number of times that coordinates with the desired first
number. For example, to enter 3, depress the switch 3 times, then wait.
STEP 5: The LED will confirm the first number by flashing BLUE slowly. Once the LED begins to flash rapidly, enter your second number by repeating step 4.
STEP 6: Turn the ignition off - the Secure Valet Switch is now programmed. Follow steps 3 - 5 to enter your Secure Valet code.
s@v@s
Advanced System Functions
19 By Firstech, LLC
Timer start mode is used to cool or warm the vehicle automatically without use of the key or the remote. While engaged, timer start will activate even
while the remote is out of range. Tap buttons simultaneously for a half second to activate timer start mode. The remote will beep once and
LEDs flash twice. Repeat the same step to turn off timer start mode. Timer start mode will be cancelled any time the vehicle is started manually or
remotely. To change from the default setting to optional settings, see your place of purchase.
t@s@m
Cold/hot start mode works in conjunction with timer start mode (see above) and the temperature sensor. It allows you to configure your timer start
feature to check the vehicle s temperature prior to starting. All of these options require programming from your local dealer.
c@O@h@s@m
You have the ability to add optional sensors from Firstech, LLC. You have the ability to protect your investment by adding a battery back up system to
protect main power to your alarm or a DAS tilt sensor to protect expensive rims and tires.
m@o@s
By Firstech, LLC 18

Other manuals for Firstech FTX2400R-SS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Firstech FTX2400R-SS and is the answer not in the manual?

Firstech FTX2400R-SS Specifications

General IconGeneral
BrandFirstech
ModelFTX2400R-SS
CategoryRemote Control
LanguageEnglish

Related product manuals