24
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE WHAT TO DO
Foaming. Incorrect amount or type of
detergent used.
See section ‘Adding detergent’ or
consult the detergent manufacturer’s
instructions.
Too much egg in the
wash load.
Increase the amount of detergent.
Rinse aid dosage level too high. Decrease the rinse aid dosage.
Rinse aid spills not wiped up. Ensure that all rinse aid spills are wiped
up when they occur.
The dish-
washer stops
suddenly
during the
wash.
Power or water supply has
been interrupted.
Check the power and water supplies.
Knocking
or rattling
sound during
wash.
Spray arm knocking
against dishes.
Pause the wash and rearrange dishes.
See sections ‘Controls and starting a
wash’ and ‘Loading’.
Dishes have been stacked
incorrectly.
Unclean
dishes.
Wash programme unsuitable
for load.
See section ‘Wash programmes and
detergent quantities’ and select a
suitable programme.
Soils were too heavily baked on. Dishes may need soaking.
Spray arm(s) unable
to rotate.
Ensure no items are obstructing the
spray arm path.
Dishwasher overloaded or
incorrectly loaded.
See the ‘Loading’ section.
The filters are
incorrectly inserted.
See section ‘Care and cleaning’.
Detergent put in the
wrong compartment.
See sections ‘Wash programmes and
detergent quantities’ and ‘Adding detergent’.
Excessive food not removed
from dishes before loading.
Scrape all food scraps off dishes
before loading.
Unsuitable detergent. Only use powdered or tablet detergent
designed for domestic dishwashers.
Not enough detergent. See ‘Wash programmes and detergent
quantities’ for recommended quantities.
You may need to adjust these to suit
your particular load and the hardness of
your water supply.
Spray arm holes are blocked. Clean the spray arm(s). See ‘Care and
cleaning’ for instructions.
The filters are blocked. Clean the filters. See ‘Care and cleaning’
for instructions.
To Next Page
Loading...
Need help?
General
