Type 1290
D101645X012
Instruction Manual
Form 5308
November 2015
www.fisherregulators.com
Type 1290 Vapor Recovery Regulator
Failure to follow these instructions or
to properly install and maintain this
equipment could result in an explosion,
re and/or chemical contamination
causing property damage and personal
injury or death.
Fisher
®
vapor recovery valves must
be installed, operated and maintained
in accordance with federal, state and
local codes, rules and regulations and
Emerson Process Management
Regulator Technologies, Inc.
(Emerson™) instructions.
If a leak develops or if the outlet
continually vents gas, service to the
unit may be required. Failure to correct
trouble could result in a hazardous
condition. Only a qualied person must
install or service the unit.
Installation, operation and maintenance
procedures performed by unqualied
personnel may result in improper
adjustment and unsafe operation. Either
condition may result in equipment
damage or personal injury. Use qualied
personnel when installing, operating
and maintaining the Type 1290 Vapor
Recovery Valve.
Introduction
Scope of the Manual
This manual provides installation, adjustment and
maintenance procedures and also parts ordering
information for Type 1290 Vapor Recovery regulator
complete with a Type EGR main valve, a Type T208P
or T208PL pilot and a Type MR95H supply pressure
regulator. Detailed instructions for installation,
adjustment and maintenance of other equipment used
with this regulator are found in separate manuals.
Product Description
The Type 1290 vapor recovery regulator is a self-
contained, pilot-operated regulator system used for
vapor recovery of blanketing gas. When blanketing gas
pressure inside the vessel rises due to thermal heating
or pump-in operations, the Type 1290 regulator senses
an increase in vessel pressure and vents excessive
internal tank pressure to a vapor recovery storage tank.
Figure 1. Type 1290 Vapor Recovery Regulator
!
WARNING
To Next Page
Need help?
General
