11
Control Panel (cont.)
3. Low
Boost here to add weight to the sound.
4. Mid
This control affects how well the instrument blends in or stands out in the mix. At
loud volumes, a midrange cut will achieve a more natural sound.
5. High
Boost highs to add “air” to the sound of the instrument.
6. Reverb
Controls the amount of the reverb effect in the Instrument channel.
7. Chorus
Controls the depth of two separate chorus presets.
8. Phase
Use the Phase switch to improve bass at low volume and suppress feedback at
high volumes.
9. Power
Connect only the included power adapter and press this switch to turn on the
amplifier. The light in the power switch will illuminate.
10. Mic Input
Connect a dynamic microphone into this XLR input for vocal or instrument. You
may also connect an outboard preamp with balanced XLR out to this input.
11. Gain
Use the Gain knob to set the signal level for the Microphone input.
12. Low
Boost here to add weight to the sound.
13. High
Boost highs to add “air” to the sound of the microphone.
14. Reverb
Controls the amount of the reverb effect in the Microphone channel.
15. Master Volume
Sets the overall level of Loudbox Micro. In general, put the Master Volume as
high as possible using less Gain to achieve the cleanest sound.
To Next Page
Loading...
Need help?
General