772/773/773-II English Instruction Sheet
Page 1
772/773/773-II
Milliamp Process Clamp Meter
Instruction Sheet
Introduction
The hand-held, battery-operated Fluke 772/773/773-II Milliamp Process
Clamp Meters (the Meter or Product) can be used in troubleshooting
transmitters, valves, PLC and DCS I/O. Unlike conventional clamp meters,
the Meter features a remote jaw that is connected to the main body via
extension cable.
Features
• In-circuit measurement of 0 mA to 24 mA dc and up to 99.9 mA dc
using a remotely connected clamp via extension cable
•
0 mA to 24 mA dc
sourcing and simulating
•
0 V to 10 V dc sourcing (773/773-I
I)
•
Loop power supp
ly 24 V dc output
•
0 V to 30 V dc measurement (773/773-II)
• Scaled mA output (773/773-II)
• Simultaneous mA measurement
via detachable clamp and mA
sourcing (773/77
3-II)
•
250 Ω HAR
T resistor for mA source
•
Electronic zero
•
Percentage span (0 % to 100 %)
•
Hold
•
Auto power off (b
attery saver)
• Display
backlight
• Measurement sp
otlight LED
PN 3351049
Februa
ry 2009 Rev. 2, 6/23
© 2009-2023 Fluke Corporation. All rights reserved.
All product names are trademarks of their respective companies. Specifications are subject to
change without notice.
To Next Page
Need help?
General
