Setting the clock
To set the time, press CLOCK. The
display will read SET TIME. Use the
memory preset numbers (0–9) to
enter in the desired time–hours and minutes. The clock will then begin
from that time.
If your vehicle is equipped with an in-dash clock, refer to Clock in the
Driver Controls chapter for instructions on how to set the time.
AM/FM Radio
/ VOL (Power/Volume): Press
to turn the radio on/off. Turn the
knob to increase/decrease volume.
If the volume is set above a certain
level and the ignition is turned off,
the volume will come back on at a nominal listening level when the
ignition switch is turned back on.
AM/FM: Press repeatedly to select
AM/FM1/FM2 frequency band.
TUNE: Turn the knob to go
up/down the frequency band in
individual increments.
DIRECT: Press DIRECT and then
select the desired radio frequency
(i.e. 93.9) using the memory preset
numbers (0–9).
SEEK: Press
SEEK to
access the previous/next strong
radio station.
SCAN: Press for a brief sampling of
all strong radio stations.
2009 Flex (471)
Owners Guide, 2nd Printing
USA (fus)
Entertainment Systems
20
To Next Page
Loading...
Need help?
General
