Timing Belt
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
2. Disconnect the battery ground cable. For additional information, refer to Section 414-01.
3. Remove the air cleaner outlet pipe. For additional information, refer to Section 303-12.
4. Remove the spark plugs. For additional information, refer to Section 303-07A.
5. Disconnect the throttle cables.
If equipped, disconnect the speed control actuator cable.
Disconnect the accelerator cable.
6. Disconnect the catalyst monitor and heated oxygen sensor electrical connectors. Detach the electrical connectors from the bracket.
7. Remove the wiring harness anchors from the valve cover studs and position the wiring harness aside.
8. Remove the valve cover.
1. Remove the studbolts.
2. Remove the bolts.
SECTION 303-01A: Engine — 2.0L Zetec 2002 Escape Workshop Manual
IN-VEHICLE REPAIR
Procedure revision date: 10/25/2004
Special Tool(s)
Crankshaft TDC Timing Peg
303-574 (T97P-6000-A)
Camshaft Alignment Timing Tool
303-465 (T94P-6256-CH)
3 Bar Engine Support Kit
303-F072
2002 Escape Workshop Manual
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2K/~MUS~LEN/20/S
To Next Page
Need help?
General
