Fossil Retrograde with Date Sweep VD86A User Manual

- 10 -
Digital MLL-004
Normal Time Display
1. Press A to display month/date for 3 seconds.
2. Press A twice (or once if date is displayed) to display seconds. Press A again to return to
Normal Time Display.
Time and Date Setting
1. From Normal Time Display, press B twice to enter setting mode; month will be displayed.
2. Press A to increase value.
3. Press B to set and advance to next setting.
4. Setting sequence is: month, date, hour, minute.
5. Press B to exit setting mode; press A to activate watch.
NOTE: Colon will flash between hour and minutes in Normal Time Display to indicate watch
is active.
A
B
Digital MLL-020
Normal Time Display
1. Press A to change to chronograph mode.
2. Press B for EL.
3. Press and hold C to display date.
4. Press and hold C and then push D to toggle month/date format.
5. Press and hold D to display alarm time.
6. Press and hold D and then push A to toggle 12/24-hour format.
NOTE: At any point in any setting mode, press A to exit setting mode.
Time and Calendar Setting
1. In normal time display, press and hold A for 3 seconds, then press A again; Tuesday flag and
seconds digits will begin flashing.
2. Press D to set seconds to zero.
3. Press C to advance to minute.
4. Press D to advance digit, press and hold D for fast advance.
5. Press C to advance to next setting value.
6. Setting sequence is: seconds, minute, hour, month, date, weekday.
7. Press A to exit setting mode.
Alarm Mode
1. In normal time display, press and hold D and then push C to toggle alarm/chime on/off.
2. Alarm will sound at preset time for 30 seconds; press D to silence alarm.
3. To test alarm, press and hold C and D simultaneously. Alarm will beep.
Alarm Setting
1. In normal time display, press and hold A for 3 seconds; Monday flag and hour will begin
flashing.
2. Press D to advance digit; press and hold D for fast advance.
3. Press C to set and advance to minute.
4. Press D to advance digit; press and hold D for fast advance.
5. Press A to exit setting mode.
Chronograph Mode
1. Press A to change to chronograph mode.
2. Press C to start/stop the chronograph.
3. Press D to reset to zero.
Split Time
1. Press D while the chronograph is running for split time.
2. Press D again to return to chronograph.
3. Repeat steps 1 & 2 to measure multiple split times.
4. Press C to finalize timing.
5. Press D to reset to zero.
D
A
C
B
DIGITAL

Fossil Retrograde with Date Sweep VD86A Specifications

General

Brand	Fossil
Model	Retrograde with Date Sweep VD86A
Category	Watch
Language	English