Do not remove spacers (if equipped) on the side wails and/or on the back of the built-in
oven, These spacers center the oven in the space provided, The oven must be centered to prevent
excess heat buildup that may result in heat damage or fire,
3" (7.6 cm)
Max,
Junction Box
2" (5 cm)Wide Wood
-. Spacerif Needed
NOTES:
1. Base must be capable of supporting 300 pounds
(136 kg) for 27" models and 375 pounds (170 kg)
for 30" models.
2. Allow at least 21 " (53.3 cm) clearance in front of
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven
decorative trim does not butt against the cabinet, or
if noise is heard on convection models, verify
dimension G to assure it is according to the required
dimension. Figure 2
27" AND 30" DOUBLE OVENS (Single Ovens see Figure 1)
4. For a cutout height greater than 491/:,'' (!25.7 cm)
add a 2" (5 cm) wide wood shim of appropriate
height to ea(h side of the opening under the
appliance side rails.
5. 30" MODELS ONLY: Fora cutout height (H) greater
than 49Ud' (126.7 cm) you can order a larger
inferior trim through a Service Center.
27" (68 6 era)Wail Oven 27 (68.6) 1 507//6 (128.1) [ 24s/s (62.5) [ 24Y2 (62.2)
3o"<762crNWa,Oven :30<76.2> _ SOTS6<12s.1> 2s_<71s> _ 24v_<62.2>
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL Max: GiM,n. J....Min: ]
30" (76 2 cm)Wail Oven J 281/,' (72.4) 29 (73.7) I 231/2(59 7) [ 48Vs (124.1)49Vs (126 7) I 30Vs (76.5) Mir_
A[[ dimensions are in inches (cm),
To Next Page
Loading...
Need help?
General
