Fujitsu ARXG45KMLA Design & Technical Manual

¢ DIP switch setting
• SW100: Remote controller address setting
When operating a number of indoor units by using a wired remote controller, DIP switch set-
ting for assigning unit number to each indoor unit is required.
The slide switches are normally set to make the unit number 00.
Remote
controller
address
Switch number
Factory setting
1 2 3 4
00 OFF OFF OFF OFF ♦
01 ON OFF OFF OFF
02 OFF ON OFF OFF
03 ON ON OFF OFF
04 OFF OFF ON OFF
05 ON OFF ON OFF
06 OFF ON ON OFF
07 ON ON ON OFF
08 OFF OFF OFF ON
09 ON OFF OFF ON
10 OFF ON OFF ON
11 ON ON OFF ON
12 OFF OFF ON ON
13 ON OFF ON ON
14 OFF ON ON ON
15 ON ON ON ON
00 01 02
Remote controller address
Indoor unit
Remote controller
• SW101-Switch 1: Setting change prohibited
• SW101-Switch 2: Setting change prohibited
• SW101-Switch 3: Fan delay setting
When the indoor unit is stopped while operating in conjunction with auxiliary heater, the indoor
unit fan operation will continue for 1 minute.
Switch 3 Fan delay Factory setting
ON Enabled
OFF Disabled ♦
- 57 -
9-1. Function settings on indoor unit
9. Function settings
DUCT TYPE ARXG24-45KMLA DUCT TYPE ARXG24-45KMLA

Fujitsu ARXG45KMLA Specifications

General

Brand	Fujitsu
Model	ARXG45KMLA
Category	Air Conditioner
Language	English